Take a look at firefly GOTO seat

Firefly

Product Care

Battery Care

Charging the battery

Before the product is used for the first time it is recommended to charge the battery fully until the LED turns green. To charge the battery, plug the adaptor into the mains socket, attach the lead (a) to the battery pack and switch on the mains power. While charging the charger LED will flash orange and will turn to green when fully charged. When charged switch off mains power, remove the adaptor plug when and disconnect the lead from the battery. The battery charge should be topped up each day until the LED turns green. When charged switch off the mains power, remove the adaptor plug and disconnect the lead from the battery pack.

Electrical Components Technical Spec

LINAK Actuator
32K500-10300410

Rated IP65
Duty Cycle Max 10% or 2 min continuous use followed by 18 min not in use.
Ambient temperature +5° to +40° C
Push Max 6000N
Pull Max N/A
Self Lock at 6000N Push
Typical speed with full load 468mm/sec
Max amps at load of 6000N is 4.7 amps
Noise level 46 dB (A)
Power input voltage 24v +- 10%

LINAK Control Box
CB8001A60-00 / CB8001A50-00

Rated IP: Not defi ned
Duty Cycle Max 10% or 2 min continuous use followed by 18 min not in use.
Ambient temperature +5° to +40° C
Rated Capacity 2.9 Ah 24v
Lead acid gel fi lled battery

LINAK Handset
HB41A00-00002

Rated IP51
Control current 100mA per channel (Max)
Ambient temperature +5° to +40° C

LINAK Battery Charger - CH01
Mains 100-240 VAC/50-60 Hz switch mode power supply
Charging voltage 27.6 VDA +- 2%
Charging current Max 500mA
Green LED for power on
Yellow LED for charging function
Yellow LED turns into green when batteries are fully charged.

Linak products may be stored in non-heated storage facilities with humidity between 0 and 100%, none condensing. None condensing means that one should not take a product an ice cold warehouse
into a room with a temperature of 20deg C. If this is done then moisture will appear on the products.