Take a look at firefly GOTO seat

Firefly

Product Care

How to Assemble

Seating Interface
The mobility base will arrive with the interface fitted in a position likely to be suitable for the seating system to be attached to it. In order to adjust the position of the interface, please refer to Fig 1a and 1b. There are 5 mounting positions to choose from.
The foremost 3 positions are suitable for the Kit seat & the rearmost 3 positions are suitable for the Mygo seat.

Remove the 4 screws (A) and nuts (B) retaining the interface and slide the interface forward or backwards as desired. Refit the 4 screws and nuts. Ensure all screws & nuts are re-tightened to ensure the seating system will be firmly attached to the base when fitted.

                 

Handle bar depth
The mobility base will arrive with the handle bar fitted in a position likely to be suitable for the seating system to be attached to it. In order to adjust the position of the handle bar, please refer to Fig 2.
Remove the 2 screws (A), 2 lap belt posts (B) and nuts (C) retaining the handle bar assembly and slide it forward or backwards as desired. Refit the attachment screws, posts and nuts.
Ensure all nuts & screws are re-tightened to ensure the handle bars are firmly attached to the base.
The lap belt posts and screws can be fitted in either the forward or rearward position, ensuring the angle of the lap belt is correct (Fig3) and it does not interfere with any parts of the base throughout its range of tilt.

 

Mounting the Seating System
To mount the Kit Seating System on themobility base release the safety locking pin atthe front of the seat by pulling the pin (A) outand rotating it through 90 degrees. Carefully tilt the seat and place it onto the chassis, locating the channel (B) at the rear of the seat over the tube at the back of the chassis (C). Pull the handle (D) at the front of the seat unit up and then pivot the seat down. Once the seat is fully lowered, release the handle and push it forward to ensure it has fully engaged on the front tube. Rotate the safety locking pin (A) so that it engages in the front of the handle.

            

To mount the Mygo Seating System on the mobility base first release the safety locking pin at the front of the seat. To do this pull the pin out and rotate through 90 degrees.Carefully lift the seat and place it into the
chassis. At the rear of the underside of the seat you will see a receiving channel. Placethis securely over the tube towards the back of the chassis. Pull the handle at the front of the seat unit up and then pivot the seat forward and down. Once the front of the seat is lowered fully, release the handle and push it forward to ensure it has fully engaged on the front tube. Rotate the safety locking pin so it engages in front of the handle. If it hits the handle then the seat is not inserted properly. Remove and repeat process outlined above.

Once the seat is mounted, ensure that the static stability of the product is checked. If the stability is less than 10˚ the user and/or attendant need to be informed using a clear warning note, to allow them to take precautions in interest of the user’s safety.